Administrator's release notes: Miscellaneous general improvements
Report attribute to show the total number of pages
You can now use the formula GetValue("PAGES") in reports to show the total number of pages in the report.
No customization is necessary, but you might want to consider using the new PAGES attribute in report templates to show the total number of pages in the report.
Support for welds when uploading to Trimble Connect
Welds are now supported when uploading to Trimble Connect.
To start using this improvement, add this line to the part.epr file in your environment:
"weld": ["WELD_SIZE1", "WELD_SIZE2", "WELD_TYPE1", "WELD_TYPE2", "LENGTH", "WELD_ASSEMBLYTYPE", "WELD_EDGE_AROUND", "WELD_INTERMITTENT_TYPE"]