Leg - 2 and 3 diagonals (177)
Bolts 2 diagonal braces and 1 horizontal brace (optional) to a tower leg. Does not create a gusset plate.
Profiles
Tower leg and braces: L
Parts created
Filler plates (optional)
Use for
| Situation |
|---|
|
|
Before you start
Create the following parts
-
Tower leg
-
1 diagonal brace to the outside of the tower leg
-
1 diagonal brace to the inside of the tower leg
-
1 horizontal brace (optional)
Defining properties
Use the following tabs in the component dialog box to define the properties of the parts this component creates:
| Tab | Contents | See also |
|---|---|---|
|
Picture |
Edge distances, dimensions that define the cut in the diagonal brace on the inside of the tower leg and the horizontal brace. |
|
|
Parameters |
Edge distances that define the location of bolt groups. |
|
|
Bolts |
Bolt properties, dimensions that define the location of bolts, and bolt pattern of bolt groups. |
|
|
General |
Connection properties, AutoDefaults and AutoConnection rule groups. |
|
|
Plates |
Option to create filler plates, filler plate properties. |
|
|
Design |
Option to use UDL with AutoDefaults, reaction forces. |
Using reaction forces and UDLs in AutoDefaults and AutoConnection |
|
Analysis |
Information used in structural analysis |
Selection order
-
Tower leg
-
Diagonal brace on the inside of the tower leg
-
Diagonal brace on the outside of the tower leg
-
Horizontal brace (optional)
-
Click the middle mouse button to create the component