General

To make a secondary guideline follow the leg face edges that are located between the guideline end points, select Yes from the Follow edges list in the property pane. Alternatively, select the secondary guideline and click on the contextual toolbar.

To adjust how rebar set bars follow a sharp or curved part corner, define the Chamfer type of the guideline at the part corner: in the property pane, select None for a sharp corner or Arc point for a curved corner. Alternatively, you can adjust the chamfer type of the selected guideline using the contextual toolbar: click the chamfer type button and then select None or Arc point to switch between the chamfer types.

Spacing properties

If you want a secondary guideline to have offsets similar to the primary guideline, select Yes from the Inherit offsets from primary list in the property pane. Alternatively, select the secondary guideline and click on the contextual toolbar.

If you want a secondary guideline to have spacing properties similar to the primary guideline, select Yes from the Inherit spacings from primary list in the property pane. Alternatively, select the secondary guideline and click on the contextual toolbar. The spacing values and ranges are automatically scaled by the ratio of the secondary guideline length to the primary guideline length.

If you want to define the secondary guideline spacing properties independently from the primary guideline, select No from the Inherit offsets from primary and Inherit spacings from primary lists, and then modify the following spacing properties as needed: