Defining Tees (105)
There are several ways to create the tees at the end of the braces:
-
On the Parts tab, specify a T profile to use.
-
On the Parts tab, specify an I profile to use. The component creates the tee by cutting the I profile. You must specify where to cut the I profile, using the Tee depth field on the Parameters tab.
-
To have Tekla Structures use two plates to create the tee, leave the Tee profile field on the Parts tab blank. You must enter t,b, and h dimensions for the tee flange and web.
Note:
You can define the Tees for each brace separately.