Stud Wall

Tekla Structures
Not version-specific
Tekla Structures
Environment
Not environment-specific
Image
Swe_Stud_Wall_1.png


Select two points in the model to set the insertion point and direction of the Stud Wall. The yellow handle symbolizes the start point and the purple handle the direction and length of the component.

Settings for the Stud Wall

1. Select appropriate height of the stud wall under the tab Studwall parameters.

Image
Swe_Stud_Wall_2_2


2. Set the center to center distance between the studs.
3. Extra studs can be set when necessary in corners.

 

Image
Swe_Stud_Wall_3.png


Example of corner where the boards are adjusted to each other and an extra stud is added.

4. The gap between the extra stud and the end stud can be set.
5. Possibility to set the creation of the insulation or not.
6. The different prefix, start numbers, name, material etc. can be set for the different parts in the stud wall.
7. When the drop down menu for Special Studs is set to Yes, additional settings appears.

Image
Swe_Stud_Wall_2_2_1

 

8. Set the center to center distance in the first space between the studs.
9. In the drop down menu for Additional Studs, it is able to add 3 more studs.

Image
Swe_Stud_Wall_4_3


10. Under the tab Details there is a possibility to set the number of boards.
11. The thickness of the boards can be set.
12. The offset can be set if the board should be drawn back (example: 50) or extended (example: -50). This can be set both sideways and to top and bottom.
13. If Special Insulation sets to Yes, the possibility to change the insulation opens.

Image
Swe_Stud_Wall_4_4


14. The edge distance of the insulation can be set and also the insulation thickness.
15. The offset of the upper and lower stud can be set.

Image
Swe_Stud_Wall_5_2


16. Under the tab Board prefix there is a possibility to set the different prefix, start numbers, name, material etc. for the boards, outer and inner.

这些内容是否有用?