Angle cut (1057)
Angle cut (1057) creates fittings at the end of a profile that is of the angle type. The fittings are created at the end that is closer to the picked point. Two types of fittings are possible: one that chamfers the angle, or one that creates a polygon cut. The type is automatically decided according to the properties on the Parameters tab.
Objects created
-
Fittings
Use for
Situation | Description |
---|---|
Fittings at the end of a profile. |
Selection order
-
Select the main part (angle profile).
-
Pick a position.
The detail is created automatically when the point is picked.
Picture tab
The Picture tab shows the angle cut.
Parameters tab
Use the Parameters tab to define the fitting properties.
Description | Default | |
---|---|---|
1 |
Height of the flange cut. Defines the height of the cut. If the distance between the reference point and the profile end is so short that height of the cut cannot be achieved, then the profile is chamfered only. |
The default value is half of the distance of the shorter edge. |
2 |
Angle of the flange cut. |
0 degrees |
3 |
Offset distance for the flange. Defines the distance between the reference point and the start edge of the cut. It can have negative values as well. |
0 mm |
Select how the flange is cut. The options are to have a cut on both flanges, or to select which flange to cut.
General tab
Click the link below to find out more:
Analysis tab
Click the link below to find out more: