Beam (command)
Create a single span beam
Create a single span beam between two points.
- In the Properties window to create a single span beam, ensure Continuous is unselected and other properties are set as required.
- Pick the start point.
- Pick the end point.
Tekla Structural Designer creates the beam.
Create a continuous beam
Create a continuous beam between points you pick.
- In the Properties window to create a multi span beam, ensure Continuous is selected and other properties are set as required.
- Pick the start point.
- Pick the end point of span 1.
- Pick the end point of span 2.
- Continue picking points to add spans.
- Pick the same point again to end the command.
Tekla Structural Designer creates the continuous beam.