Reset Autodesign to
off...
|
Allows you to
control what happens to individual steel and concrete member
auto design settings and isolated foundation auto design
settings at the end of the design process. The options are: - Always: the auto design setting is automatically cleared at the
end of the design process, so that each member is put into
check mode.
- Never: the autodesign settings is always retained as it is at
the end of the design process.
- When check status is at worst:
- Pass: The auto design setting is only automatically
cleared at the end of the design process for members
with design status Pass.
- Warning: The auto design setting is only automatically
cleared at the end of the design process for members
with design status Pass or Warning.
- Fail: The auto design setting is only automatically
cleared at the end of the design process for members
with design status Pass, Warning, or Fail.
- Invalid: The auto design setting is only automatically
cleared at the end of the design process for members
with design status Pass, Warning, Fail or Invalid.
- Beyond Scope: The auto design setting is only automatically
cleared at the end of the design process for members
with design status Pass, Warning, Fail, Invalid, or
Beyond Scope.
Tip:
The most
practical use of When check status is at worst is to set it to Pass and start with all members in auto design mode. At the
end of the first design run, passing members would be set to
check mode, allowing you to focus on the remaining members
still in auto design mode.
|