There are new template attributes for surfaces and pour units. Start using them in filters, templates, and reports. Also check the inquiry report.
Surfaces
There is now a template attribute ATTACHED_TO for checking if the surface is attached to a part or a pour.
The possible values are:
Pour units
There is now a template attribute ADDED_TO_POUR_UNIT for checking how the object is added to a pour unit (automatically or manually).
The possible values are:
- 0 (unassigned, or modified after the pour units were calculated the last time)
- 1 (manually assigned)
- 2 (automatically assigned)
This attribute is added to the template category in filters and to template attributes for the following object types:
- ASSEMBLY
- BOLT
- CAST_UNIT (only precast, not for cast in place)
- MESH
- REBAR
- SINGLE_REBAR
- SINGLE_STRAND
- STRAND
- STUD
