Number a series of parts or other model objects

Use the Number series of selected objects command to only number objects that have a certain prefix and start number. This enables you to limit the numbering to certain series of objects only, which can be useful in large models.

Before you start, we recommend that you plan the numbering series carefully, and split the model into smaller numbering series, for example by area or phase, and object type.

Select the objects that have the desired prefix and start number.

Only objects that have the same prefix and start number as the selected object will be numbered.
On the Drawings & reports tab, click Perform numbering > Number series of selected objects.

Tekla Structures opens the Numbering preview dialog where you can check the numbering results before assigning position numbers to the objects.
If you are not happy with the proposed position numbers, click Reject numbers. Then adjust the model objects and the numbering settings as needed, select the required objects, and start the command again.
When you are happy with the proposed position numbers, click Assign numbers.

Tekla Structures numbers all new and modified objects in the specified numbering series.