If a part is behind another part in the drawing so that it is hidden, you can select whether to show the mark frame and leader line of the hidden part with a dashed or a solid line.
- On the Drawings & reports tab, click Drawing properties and select the drawing type.
- Load drawing properties that are as close to the ones you need as possible.
- Single-part, assembly and cast unit drawings: Click View creation , select the view and the properties that you want to change, and click View properties.
- Click Part mark.
- In part mark properties, go to the General tab.
- Use one of the following options:
Use hidden lines for hidden parts: Yes
Part mark frame and leader line are shown with a dashed line.
Use hidden lines for hidden parts: No
Part mark frame and leader line are shown with a solid line.
- Single-part, assembly and cast unit drawings: Click Save to save the changes in view properties and Close to return to drawing properties.
General arrangement drawings: Click OK.
- Click Save to save the drawing properties, then click OK and create the drawing.