1. Hem
  2. Tekla Structures
  3. Create drawings
  4. Define automatic drawing settings
  5. Define drawing views
  6. Define automatic section view properties
  7. Define the location for end views and section views

Define the location for end views and section views

Tekla Structures
2018
Tekla Structures

Define the location for end views and section views

You can always place section views and end views next to the main view or in any empty location in a single-part, assembly, and cast unit drawing.

  1. On the Drawings & reports tab, click Drawing properties and select the drawing type.
  2. Load drawing properties that are as close to the ones you need as possible.
  3. Click Layout and go to the Other tab.
  4. Set Align end views with main view to Yes to place the views next to the main view.
  5. Set Align section views with main view to Yes to place the views next to the main view.
  6. To save the changes in a drawing properties file, click Save at the top.
  7. Click OK and create the drawing.

    If you select No , Tekla Structures places the section and end views in any available location.

Example

End and section views in any location ( No selected).

End and section views beside the main view ( Yes selected).

Var det här användbart?
Föregående
Nästa