Validation settings
The
page allows you to control the checks that are applied when the current model is validated.Item | Description |
---|---|
Error limit for length |
Allows you to control when an error is displayed when very short analysis elements are detected. |
Warning limit for length |
Allows you to control when a warning is displayed when very short analysis elements are detected. |
Error limit for quality |
Allows you to control when an error is displayed when poor quality 2D elements are detected. Note:
2D element quality depends on two things: skew and aspect ratio. 0% is bad quality: a squashed triangle tends towards bad quality, whereas 100% is perfect quality, so an equilateral triangle is perfect quality. |
Warning limit for quality |
Allows you to control when a warning is displayed when poor quality 2D elements are detected. |
Check for validation warnings |
Allows you to specify which model, analysis, and design validation checks are performed. If a box is cleared, the validation check is not performed. |