Design members (command)

Tekla Structural Designer
2021
Tekla Structural Designer

Design members (command)

Command Description
Design members
  • If the member s are not in a design group -
    • Performs a check or design (according to individual autodesign settings) of the selected members.
  • If the members are in design groups (and design using groups is active)
    • Performs a check of those members in the selection that are in check mode.
    • Performs a design of those members in the selection that are in autodesign mode (for the group's set of design forces), and:
      • Updates all other members of the same group to use the same design, (irrespective of whether they are in the selection).
      • Checks all other members of the same group (irrespective of whether they are in the selection).
Note: Design members does not perform an analysis before the design - it always uses the existing analysis results, (even if the analysis status is 'Out of Date').
Note: This command requires at least one member in the branch to be in auto-design mode.
Var det här användbart?
Föregående
Nästa