Round tube (23)

Round tube (23) connects two round tube profiles with a fitting and welds.

Objects created


Situation	Description
	Connection between two round tubes. Fitting and welds are created.

Select the main part (first round tube).
Select the secondary part (second round tube).

The connection is created automatically when the secondary part is selected.


	Part
1	Round tube
2	Round tube

Use the Picture tab to control the dimensions of the secondary round tube fitting and the gap between the round tubes.


	Description	Default
1	Pop mark offset. You can define the offset if you have set the Position of pop mark option to At minimum angle, At maximum angle, or Both.	`100 mm`
2	Pop mark diameter. You can define the diameter if you have set the Position of pop mark option to At minimum angle, At maximum angle, or Both.	`10 mm`
3	Gap between the main and the secondary round tube.


Option	Description
	Default The secondary round tube is cut with the main round tube. AutoDefaults can change this option.
	The secondary round tube is cut with the main round tube.
	The secondary round tube is fitted to the center line of the main round tube and then cut.


	Description
1	Define the secondary part cut distance from the main part center.

Select the position of the pop mark.

Use the Parameters tab to control whether welds are created and to define the rotation angle and cut tolerance.


Option	Description
Weldings	Define whether welds are created between the round tubes.
Rotation angle of cut part	Define the rotation angle of the cut in the main round tube. In some cases it is necessary to rotate the cut part in the main round tube to make sure the cut is shown correctly. The default is that the cut part is not rotated.
Cut tolerance of sec	Define the cut tolerance of the secondary round tube.

Click the link below to find out more:

Click the link below to find out more:

Click the links below to find out more:

Click the link below to find out more: