Display analysis results in a Results View
To display graphical analysis results, first
switch the view to the 
Results View regime (1),
then click the Results tab (2).
After selecting the analysis method
(3) and loading (4), results can then be displayed by making
selections from the ribbon.
| Ribbon Group | Click the link to find out more |
|---|---|
| Reactions | Display reactions |
| 1D Results | Display 1D results |
| Display 1D deflections | |
| Animate 1D and 2D deflections | |
| Sway Drift and Story Shear | Display sway, drift, and story shear |
| Notional Loads | Display notional forces, minimum lateral loads and seismic equivalent lateral forces |
| 2D Results | Display forces in 2D elements |
| Display stresses in 2D elements | |
| Display 2D deflections | |
| Animate 1D and 2D deflections | |
| Display AsReq contours | |
| 2D Integrated Results Note: Result lines and
result strips must be created before they can be
displayed. |
Display wall lines |
| Display core lines | |
| Manage, display and design result lines | |
| Manage and display result strips | |
| Mode Shapes | Display mode shapes |
| RSA Results | RSA seismic results |
If required, adjustments can be applied to the diagrams as follows:
- To change contour intervals and colors, see Customize the display of 2D contours
- To adjust the amplitude of the diagrams, see Change result diagram scale settings
- In 2D views, it is sometimes necessary to switch to an isometric projection, see Display 2D view in isometric projection
Note: When Tekla Structural Designer has performed several analysis types, the results of each analysis are held
separately. Therefore, there is no need to re-perform a particular analysis to
recall its results.