Wind wizard (ASCE 7)

Tekla Structural Designer
2021
Tekla Structural Designer

Wind wizard (ASCE 7)

To access this configuration of the wind wizard the wind loading code has to be set to ASCE 7. Each of the following ASCE 7 code years are supported: -05, -10 & -16.

Once the wall and roof panels are in place, you use the wind wizard on the Load tab to define sufficient site information to calculate the velocity pressures for the required wind directions and heights around the building. Minimum design wind loads can also be calculated if required.

Note: Unless explicitly noted otherwise, all clauses, figures and tables referred to in the topics in this section are from ASCE 7-10. Ref 1
Was this helpful?
Назад
Далее