If your shop uses other drill types than
automatic and manual, you can add the necessary drill types to
Tekla EPM. Then, you can use the new drill types in any estimating job.
-
In the Drill
Maintenance dialog box, click the Drill
Maintenance ribbon tab.
-
On the menu, select
Drill Type Maintenance.
-
In the Drill Type Maintenance dialog box, click New.
-
Add a description and abbreviation for the drill type.
-
In the Labor
Group list, select which labor group the drill type belongs to.
The selection determines where Tekla EPM saves the labor time used in drilling. Normally, drill times are saved to
the Punch labor group.
-
Click
Add.
The new drill type is created and will be available in Drill
Maintenance.
Note that the new drill type will only be visible and available for filtering
in the Drill
Maintenance dialog box once you create a drill rate with the new drill type.
-
To close the
dialog box, click the Close button (X) in the upper-right
corner.