Defines the order of the bar layers. The smaller the layer number, the closer to the concrete surface the bar layer is. You can use both positive and negative values.

By default, Tekla Structures arranges the bar layers according to their creation order. The bar layer that is created first is closest to the concrete surface.

You can also adjust the layer order by using these options on the contextual toolbar:

Note that if you copy properties from one leg face to another, the layer number is not copied.

Distance between the leg face and the bars.

A negative value moves the bars outside the concrete.

Shows if the bars are flipped over to the other side of the leg face (Yes) or not (No). The default value is No.