Set the analysis type and loading for viewing analysis results

Tekla Structural Designer
2021
Tekla Structural Designer

Set the analysis type and loading for viewing analysis results

When Tekla Structural Designer has performed several analysis types, the results of each analysis are held separately. Therefore, there is no need to re-perform a particular analysis to recall its results.

  1. On the ribbon, go to the Results tab.
  2. In the Result Type group, select the required analysis method.
    Note: If you select: 1st order modal, 2nd order buckling, 1st order RSA seismic or 2nd order RSA seismic analyses, you should also choose the Mode to be displayed.
  3. In the Result Type group, if required, click Imposed/Live (US) Load Reduction if you want to take into account reductions when viewing axial forces in a loadcase or combination in which reductions have been applied.
  4. In the Result Type group, click Strength Factors, or Service Factors, as required, to control which factors are used when displaying results for combinations.
  5. In the Loading list, click either the Select Loadcase, Select Combination, or Select Envelope button.
  6. In the Loading list, select the desired loadcase, combination, or envelope.
You can now proceed to select the diagram to be displayed.
Esta informação foi útil?
Anterior
Seguinte