Run 3D only (Static)

Tekla Structural Designer
2021
Tekla Structural Designer

Run 3D only (Static)

3D only (Static) analysis can be used to save time during scheme design, for example while addressing overall stability, sway, drift, wind drift, etc.

To run a 3D only analysis proceed as follows:

On the Analyze tab, click 3D only (Static).

Tekla Structural Designer performs the following 3D analyses:

  • 1st order linear/non-linear
  • 2nd order linear/non-linear (only if this has been specified by the user in Design > Design Settings > Analysis)

At the end of the analysis if a 2D or 3D view is active it is switched to a Review View.

Was this helpful?
Anterior
Seguinte