1 Single Lattice Bracing

Tekla Structures
2021
Tekla Structures
2020
Tekla Structures
2019i
Tekla Structures
2019
Tekla Structures
2018i
Tekla Structures
2018
Tekla Structures
Environment
Not environment-specific

Contents

Purpose and description
System Requirements
Using the 1 Single Lattice Bracing
1 Single Lattice settings
Additional information

Purpose and description

A component to easily and quickly add Single Lattice Bracing to a transmission tower.

System requirements

Tekla Structures.

Using [extension]

To use the component:
  1. From the component catalog select the 1_Single_Lattice_Bracing component.
Image
Thumbnail.jpg

  1. Select the parts in the model (2 No.)
Image
Cross_Partsl.jpg

  1. Select the input points
Image
Cross_Points.jpg

1 Single Lattice Bracing settings

Parameters Tab

Image
Dialog1.jpg


PropertyDescription
Image
Dialog1_Spacing.jpg
Options to specify the bracing spacing dimensions.

All dimensions are along the leg.
Image
Dialog1_BM.jpg
The Leg Gauge Line dimensions of the profiles are read automatically from the GaugeLines.dat file (in the model, firm or system folder).
These can be over written by the user if necessary.
Image
Dialog1_ON_OFF.jpg
Options to turn On/Off the bracing sets.
The bottom set is always created.
If more than 5 sets are required then additional bracing can be added in the model.
Image
Dialog_Offsets.jpg
Options to specify Offsets to the bracing ends along the legs.
Image
Dialog1_Orientation.jpg
Option to specify the input Direction for the bracing. (left/Right)
 
Image
Dialog1_Orientation1.jpg
Option to specify the input Orientation for the bracing. (Inside/Outside)
Image
Cross_Construc.jpg
Option to show additional construction lines in the model on the Gauge line of the legs.

Profiles Tab

Image
Dialog1_Profiles.jpg


PropertyDescription
Image
Cross_Profiles_tab_Gauge.jpg
The Bracing Gauge Line dimensions of the profiles are read automatically from the GaugeLines.dat file (in the model, firm or system folder).
These can be over written by the user if necessary.
Image
Cross_Profiles_tab_Profile.jpg
Option to specify the bracing profile.
The component is expecting equal L profiles and will not give the correct results with unequal profiles or other profile shapes.


Additional information

  • Only 5 sets of bracing can be applied at once
  • The Component direction must be set according to the directions shown in the dialog before applying
Czy to było pomocne?