Apply member loads

Tekla Structural Designer

2020

Tekla Structural Designer

Apply member loads

By using member loads, you can apply loads to one-dimensional members, such as beams, columns, and braces.

Tekla Structural Designer allows you to create and apply the following types of member loads:

• Full-length uniformly distributed loads (UDLs)

• Partial-length uniformly distributed loads (UDLs) and variable distributed loads (VDLs)

• Trapezoidal loads

• Point loads and Moment loads

• Full-length torsional uniformly distributed loads (UDLs)

• Partial-length torsional uniformly distributed loads (UDLs) and variable distributed loads (VDLs)

 

Czy to było pomocne?

Tak

Nie

Czego brakuje?

Zachowaj

Leave this field blank

Wstecz

Dalej