Slab/Mat overhang properties

Tekla Structural Designer
2023
Tekla Structural Designer

Slab/Mat overhang properties

General
LengthofBeam
  • When checked, the overhang is created by a single click on a supporting beam along the the slab edge.
  • When unchecked, the overhang is created by clicking two points along the slab edge.
EdgeParallel
  • When checked, the overhang is created with a straight edge.
  • When unchecked, the overhang is created with a curved edge.
Curvature Specifies the overhang curvature, (when EdgeParallel is unchecked).
Tapered
  • When checked, the overhang varies in width. (Width1 to Width2)
  • When unchecked, the overhang is a constant width (Width1).
Width1 The width at end 1 of the overhang.
Width2 The width at end 2 of the overhang, (when tapered).
Was dit nuttig?
Vorige
Volgende