Apply and manage model settings
To apply and manage the various defaults and settings that apply to the current project, see the following instructions.
-
On the Home ribbon, click
Model Settings.
- Adjust the Model Settings according to your needs.
-
After adjusting the settings, do one of the following:
To Do this Apply the changes to the current project -
Click OK.
To Do this Save the changes back to the active settings set for future use -
Click Save...
To Do this Cancel the changes -
Click Cancel.
To Do this Revert to the model settings specified in the active settings set -
Click Load...
Note:Clicking Load... loads all of the model settings from the active settings set, not only those specified on the current page of the Model Settings dialog box.
Analysis options and design options are not loaded.
-