Validate the model
You can validate the model at any time in order to trap errors that will cause the solver to fail before the model is submitted for analysis. Validation is also automatically performed during design.
Note: For a list of validation issues and how to resolve them, refer to this support article.
Run model validation
On the Model or Load tab, click
Validate.

Tekla Structural Designer performs the validation checks. If your model contains any issues, warning messages appear.
Adjust the conditions considered in model validation
-
On the Home tab, click
Model Settings.
- Go to the Validation page.
- Select the conditions that you want Tekla Structural Designer to consider during validation checks.
- Click OK.