Timber member design commands

Tekla Structural Designer
2021
Tekla Structural Designer

Timber member design commands

By right clicking over the required member in a view or appropriate branch of the Project Workspace, the following interoperative commands can be accessed:

Note: Initially only Design using Tekla Tedds command is shown, but once this has been run the other commands then become available.

Each of the above offers a sub-menu of choices, depending on context:

  • > Model
  • > Member
  • > Group
  • > Selection
  • > <Substructure name>
Note: Check using Tekla Tedds > Model is repeated on the Design ribbon tab as Check in Tedds
Was this helpful?
前へ
次へ