Grouping settings

Tekla Structural Designer
2021
Tekla Structural Designer

Grouping settings

The Home > Model Settings > Grouping page allows you to control the tolerance applied when members are grouped in the current project.

Item Description

Maximum edge length variation

Allows for a tolerance to be applied to the automatic grouping. A member can only be included in an existing group if its span length is within the specified tolerance of the group's (average) span length.

Maximum length variation

Allows for a length tolerance to be applied to the automatic grouping of trusses. A truss can only be included in an existing group if its span length is within the specified tolerance of the group's (average) span length.

Maximum height variation

Allows for a height tolerance to be applied to the automatic grouping of trusses. A truss can only be included in an existing group if its height is within the specified tolerance of the group's (average) height.

役に立ちましたか?
前へ
次へ