Design Settings > Steel > General (Eurocode only)
Setting | Description |
---|---|
Partial safety factors |
|
Use user defined partial safety factors |
When Use user defined partial safety factors is selected, the options to define partial safety factors are enabled. Otherwise, the corresponding country defaults will be used. Note: Default for this setting is unselected.
|
Resistance of cross-sections, γM0 |
Specify a user-defined value for this partial safety factor as required. |
Resistance of members to instability, γM1 |
Specify a user-defined value for this partial safety factor as required. |
Resistance of cross-sections to tension, γM2(EC3 - Part 1-1) |
Specify a user-defined value for this partial safety factor as required. |
Resistance of joints, γM2(EC3 - Part 1-8) |
Specify a user-defined value for this partial safety factor as required. |