Review member design

Tekla Structural Designer
2020
Tekla Structural Designer

Review member design

Review member design status

  1. Open a view and change the view regime to Review View.
  2. On the Review ribbon, in the Design group, click Status.

    Color codes display the design status of each member.

    Tekla Structural Designer uses the following classifications:

    Status

    Description

    Pass

    The member has passed all design checks.

    Fail

    The member has failed one or more design checks.

    Warning

    Although the member has passed the design checks, one or more warnings have been issued. Review the warnings before deciding if you need to take further action.

    Error

    The member currently cannot be designed because an error has occurred.

    Beyond Scope

    The member cannot be designed because its design is beyond the scope of Tekla Structural Designer.

    Unknown

    The member has not been designed.

Review member design ratios

  1. Open a view and change the view regime to Review View.
  2. On the Review ribbon, in the Design group, click Ratio.

    Color codes display the design ratio of each member. N/A is assigned to members that have no ratio or whose ration is smaller than the lowest band. N/A also indicates members that either are beyond scope or have yet to be designed.

Review member depth ratios

  1. Open a view and change the view regime to Review View.
  2. On the Review ribbon, in the Design group, click Depth Ratio.

    All steel and concrete beams are color coded to indicate their span to depth utilization ratios.

Was this helpful?
前へ
次へ