2022i SP6: New features, improvements, and important fixes

Tekla PowerFab
2022i
Tekla PowerFab Tekla PowerFab GO

2022i SP6: New features, improvements, and important fixes

The latest Tekla PowerFab service pack is available in Tekla Downloads.

修正リスト

不具合番号 開発分野 説明
EPM-7599 Estimating

Previously, when exporting an estimate to a KISS file, holes without bolts are exported as regular holes. This issue has now been fixed.

EPM-7740 Estimating

In the combining run optimization settings, the multing/nesting software option Other has been renamed to Extension.

EPM-7781 Project management

Previously, in Project Management, the Job # Regular Expression setting in Company Standards was not being enforced on new jobs. This issue has now been fixed.

EPM-7750 Production control

Previously, In Production Control, the Completed Station Details report showed the quantity of the first completed record in the item header instead of the total line item quantity. This issue has now been fixed.

EPM-7778 Production control

Previously, in Production Control, when adding to a cut list, if there was a quantity greater than 1 of an identical cutting pattern and a partial quantity had been received, then only the on-order quantity was added to the cut list. This issue has now been fixed.

EPM-7820 Production control

Previously, in Production Control, an error occurred when attempting to open the Master Shipping List report when a load had been shipped with no parts, only Additional on Load items. This issue has now been fixed.

EPM-7759 Combining

Previously, during a revised IFC import into a Combining job, parts removed from an assembly were not actually deleted from the job. This issue has now been fixed.

EPM-7600 Integrations

A remote permission setting has been added to grant the user permissions to perform external nesting actions through the Tekla PowerFab Open API.

EPM-7739 Integrations

Previously, when a specific external combining software was specified to perform a nest or mult and there were extensions enabled and installed, the option to export the combining run to extensions was available even if the external software chosen did not use extensions. This issue has now been fixed.

EPM-7758 Integrations

A new option has been added to SigmaNest Settings to select if you want to Sync Job Reserve information. Default behavior is to sync information on what sheets are reserved and to what jobs. Clearing the checkbox does not transfer that information to SigmaNest, and therefore it maintains the same SigmaNestID before and after nesting and reserving inventory to a job.

役に立ちましたか?
前へ
次へ