Sign in to Tekla EPM

Tekla PowerFab
Tekla PowerFab Tekla PowerFab GO

Sign in to Tekla EPM

To sign in to Tekla EPM for the first time, do the following:

  1. Start Tekla EPM.

  2. In the Trimble ID section of the Log In dialog box, click Sign in.

    If you do not have a Trimble Identity, see Create your Trimble Identity.

  3. In the Trimble Identity dialog box, type your email address and password.
  4. If you want to stay signed in with this Trimble Identity, select the Stay signed in check box.
  5. Click Sign in.

    The Trimble Identity dialog box closes automatically.

  6. If necessary, in the Configuration list of the Log In dialog box, select which configuration of Tekla EPM you want to use.

    Note that you only need to select a configuration if you have purchased more than one configuration of Tekla EPM.

  7. Type your Tekla EPM username and password.

    The username and password need to be created by an administrator in your company.

    The default Tekla EPM sign-in information for administrators is:
    • username: admin

    • password: fab

    If you have previously used Fabsuite, your username and password are the same as in Fabsuite.

  8. Click Log In.
  9. In the Enter Value dialog box, do either of the following:
    • To save your Trimble Identity and use it automatically when you sign in to Tekla EPM, select Yes in the list.
    • To not use your Trimble Identity automatically when you log in, select No in the list.
Was this helpful?