Manually defined combinations (Eurocode)

Tekla Structural Designer
Modificato: 5 Mag 2021
2024
Tekla Structural Designer

Manually defined combinations (Eurocode)

As you build up combinations manually, the combination factors are automatically adjusted as loadcases are added and removed from the combination.

If you add/remove a loadcase type from a combination - the factors are defaulted as follows:

  • 'Self weight' - default Strength factor = 1.35, default Service factor = 1.0

  • 'Slab Dry' - default Strength factor = 1.35, default Service factor = 1.0

  • 'Dead' - default Strength factor = 1.35, default Service factor = 1.0

  • 'Imposed'- default Strength factor = 1.5, default Service factor = 1.0

  • 'Roof Imposed'- default Strength factor = 1.5, default Service factor = 1.0

  • With an Imposed loadcase

    • 'Wind' - default Strength factor = 0.75, default Service factor = 0.5

    • 'Snow' - default Strength factor = 0.75, default Service factor = 0.5

  • With No Imposed loadcase

    • 'Wind' - default Strength factor = 1.5, default Service factor = 1.0

    • With Wind loadcase

      • 'Snow' - default Strength factor = 0.75, default Service factor = 0.5

    • With no Wind loadcase

      • 'Snow' - default Strength factor = 1.5, default Service factor = 1.0

  • 'Snow drift'- default Strength factor = 1.0, default Service factor = 1.0
  • 'Temperature'- default Strength factor = 1.0, default Service factor = 1.0

  • ‘Settlement'- default Strength factor = 1.0, default Service factor = 1.0

È stato utile?
Precedente
Successivo