To mult and nest materials in the
Combining dialog box, use the Combine command. You can then save and review the combining results.
-
In the Combining dialog box, click the Combining ribbon tab.
-
On the menu, select
Combine.
The Select Combining Run dialog box opens. When you are performing the first combining run for a
combining job, the list in the dialog box is empty.
-
Click a desired combining option
to select it.
The options are:
-
Mult: combines linear items, like beams and angles.
-
Nest: combines items that have area, like plates or gratings.
- Mult & Nest: combines all items.
The Combining Run Filters dialog box opens.
Note:
Filtering items is
optional, so you can skip steps 4 to 7 if you do not want to filter out
items from the combining run.
-
To only combine specific types of materials, select a filter type in the Type list, and click Select.
-
In the Filter dialog box, do one of the following depending on the filter type:
- Click the arrow buttons to move the items that you want to combine to the Included list.
- Type
the maximum and minimum values for the items that you want to combine.
-
Click
OK to apply the filter.
Repeat steps 4 to 6 for each filter type that you want to set.
-
In the Combining Run Filters dialog box, click OK.
-
To ensure that you are using the correct settings, click the Optimizations, INV Filter, and Suppliers buttons.
If necessary, you can modify the settings.
-
To combine the materials, click
the button at the bottom of the Combining Run Filters dialog box, or press F4.
Tekla
PowerFab combines the materials. After the combining process is finished, the Combining Run Results dialog box opens.
- Piece mark items included with the selected stock lengths are displayed at the lower-left
section of the dialog box.
- Combining results are shown in both the display area and in the summary grid at the
lower-right section of the dialog box.
- The material cost represents the pricing of the materials in the pricing database that was
used in the combining run.
Tip:
You can save the combining run to view it
later and compare it with another combining run. To do so, click Save Combining Run at the bottom of the Combining Run Results dialog box. No cut lists are generated when you save the combining run.