Single Brace Out

Tekla Structures
2021
Tekla Structures
2020
Tekla Structures
2019i
Tekla Structures
2019
Tekla Structures
2018i
Tekla Structures
2018
Tekla Structures
Environment
Not environment-specific

Contents

Purpose and description
System Requirements
Using the Single Brace Out
Single Brace Out settings
Additional information

Purpose and description

A component to apply a connection to an outside brace

System requirements

Tekla Structures.

Using the Single Brace OUT

To use the component:
  1. From the component catalog select the Single_Brace_Out component.
 
Image
SBO_Thumb.jpg

  1. Select the parts in the model (2 No.)
 
Image
SBO_Input.jpg

 

Single Brace Out settings

Parameters Tab

Image
SBO_Dialog.jpg


PropertyDescription
Image
SBI_BM.jpg
The Gauge Line dimensions of the profiles are read automatically from the GaugeLines.dat file (in the model, firm or system folder).
These can be over written by the user if necessary.
Image
SBI_Fact.jpg
Option to specify a set dimension to the end of the brace, or select a factor. (user input number*hole diameter)
Switch BMOption to switch the face from which the gauge line is shown. (dummy arrows in the model will show the face).
Normally this is from the back of the L profile but in some cases it may be shown from the leg instead, the user can use this option to over ride the Tekla default.
Image
DB_Cut.jpg
Option to turn off leg cut
Image
DB_Cut1.jpg

 

  

Additional information

  • The Component is expecting equal L profiles, any other profile will give incorrect results.
Was this helpful?