Thomas Panels Non-Standard Anti-Sag (57)
Not version-specific
Tekla Structures
Environment
Not environment-specific
The Thomas Panels and Profiles Non-Standard Anti-Sag macro can be used to define spring fixes and angle braces individually between selected purlins.
Before and after
Image
Image
Notes
- Any modification of the selected parts will cause this macro to be updated.
- Most of the data required for this macro is fixed by TPP and stored in a series of data files supplied with Tekla Structures. Where standard data is not applicable, then certain items can be modified through the Parameters tab of the properties panel, but it is also possible to tailor the data files to individual requirements. This would require assistance from Tekla Structures support.
- All purlin lengths must be parallel.
Selection order example
When selecting a position ensure Snap to nearest points (points on line)Image
- Purlin
- Purlin
- Pick a position along a purlin
Image
See also
Thomas Panels cold rolled - Important informationThomas Panels Non-Standard Anti-Sag (57) - Parts tab
Thomas Panels Non-Standard Anti-Sag (57) - Parameters tab