Kingspan Multichannel Base Cleat (4) - Parameters tab
Not version-specific
Tekla Structures
Environment
Not environment-specific
Use the Parameters tab in the Kingspan Multichannel Base Cleat Properties panel to control how the autoform/cleats are defined within Tekla Structures.
Image
| Option | Description | Default | Other |
|---|---|---|---|
| Base Cleat Type (Cold rolled, Hot Rolled, Autoformed) | This determines what type of cleats/autoformed end is to be used in this detail. | The default is set to Cold rolled. | |
| Cleat to (NOT in Compound Autoform) (Both Sides, InSide Only, Outside only) | This specifies where to place the cleats in the detail. This option is ignored if Base Cleat Type is set to Autoformed. | The default is set to Both Sides. | |
| Clearance | This is the distance from the base of the cleat to the edge of the Multichannel. Has no effect on the autoforms. | The default setting is 0mm. | |
| Diameter of holes (14mm, 18mm) | This specifies the diameter in mm to be used for the holes where the standard manufacturer's size is not to be used. | The default is set to 14mm. |
See also
Kingspan cold rolled - Important informationKingspan Multichannel Base Cleat (4)