Kingspan Autoform Detail (3)
Environment
Not environment-specific
The Kingspan Autoform Detail joint only works with Kingspan Multichannel sections and is used to create an autoform at the end of a Multichannel.
Before and after
Image
Image
Image
Notes
- Any modification of the selected parts will cause this joint to be updated.
- If specific values are entered under the Parameters tab, thus overriding the default settings then non standard parts may be created.
Selection order example
- Multichannel
- Pick a position along the multichannel where the autoform should be created
Image
See also
Kingspan cold rolled - Important informationKingspan Autoform Detail (3) - Parameters tab
Kingspan Autoform Detail (3) - Bolts tab