ASDO Picking procedure for the tie rod system

Tekla Structures
Not version-specific
Tekla Structures
Environment
Not environment-specific

When applying the tie rod system into the model, model up help lines from hole to hole to determine the midpoint of the centre disc and the plate on the column. Snap to the intersection of the help lines and set direction of the centre disc to the right to get the right position in depth.

Image
ASDO_11.PNG

Snap the tie rod system to the plate hole attached to the column, and then to the centre disc hole, left to right, to get the position right of the tie rod system. Check that the sizes of the components are the same.

Was this helpful?