ASDO centre disc

Tekla Structures
Not version-specific
Tekla Structures
Environment
Not environment-specific

Select two points in the direction on how you wish to place the centre disc. It is Important to set the start point on the left and the direction on the right to get the position in depth of the component correct. The yellow handle symbolizes the start point and the purple handle the direction of the component.

Image
ASDO_3.PNG

Settings for the centre disc

1. Select appropriate size of the centre disc and press load. All values are automatically loaded into dialog.
Image
ASDO_4.PNG

2. Under the parameters tab different settings can be made for name etc. Recommendation is to keep the default settings.
3. Type is generated from size and selections made.
4. Only angles between 45-90 degrees are allowed. If another angle is written which isn’t within the marginal, either 45 or 90 degrees is chosen automatically.
Was this helpful?