Ayrshire Diagonal Tie Cleat (82)
Not version-specific
Tekla Structures
Environment
Not environment-specific
The Ayrshire Diagonal Tie Cleat macro allows the placing of a single diagonal tie between two holes/bolts.
Before and after
Image
Image
Notes
- It is important to realise that any modification of the parts to which this macro applies is likely to cause incorrect results in the model. This is because the items created by a macro are not redefined when changes are made to the previously selected members. If it is necessary to change any of the members upon which the macro is dependent then first delete all the parts created by the macro, make the required changes and finally re-apply the macro.
- To reduce unnecessary parts in the models/clarity the end brackets are not modelled.
Selection order example
When selecting a bolt ensure both Select boltsImage
Image
When selecting a point ensure Select all
Image
- Bolt
- Bolt
Image
See also
Ayrshire cold rolled - Important informationAyrshire Diagonal Tie Cleat (82) - Parts tab
Ayrshire Diagonal Tie Cleat (82) - Parameters tab