Ayrshire Diagonal Tie Column (81)
Not version-specific
Tekla Structures
Environment
Not environment-specific
The Ayrshire Diagonal Tie Column macro allows the placing of a single diagonal tie between a hole on a strut and a point on a column.
Before and after
Image
Image
Notes
- It is important to realise that any modification of the parts to which this macro applies is likely to cause incorrect results in the model. This is because the items created by a macro are not redefined when changes are made to the previously selected members. If it is necessary to change any of the members upon which the macro is dependent then first delete all the parts created by the macro, make the required changes and finally re-apply the macro.
- To reduce unnecessary parts in the models/clarity the end brackets are not modelled.
- Counter formed holes are determined by the type of hole at the tie end of the rope.
Selection order example
When selecting a bolt ensure both Select boltsImage
Image
When selecting a point ensure Select all
Image
- Bolt
- Column
- Point
Image
See also
Ayrshire cold rolled - Important informationAyrshire Diagonal Tie Column (81) - Parts tab
Ayrshire Diagonal Tie Column (81) - Parameters tab