Ayrshire Non-Continuous Rail (106) - Parameters tab
Not version-specific
Tekla Structures
Environment
Not environment-specific
Use the Parameters tab in the Ayrshire Non-Continuous Rail Properties panel to control how the connecting members are defined within Tekla Structures.
Image
| Option | Description | Default | Other | ||||
|---|---|---|---|---|---|---|---|
| Secondary member cut back | This determines the position to which the end of the secondary members are fitted, measured from the extremities of the primary member. | The default will give a minimum clearance of 10mm from the primary which will be rounded to give a whole value when measured from the centre-line of the primary. | Image
| ||||
| Angle Cleat Length | This sets the the length of the cleat. | This value will come from the data files. | Image
| ||||
| Place Cleats on (Above, below) | This specifies the positions where cleats are to be applied. The position is determined relative to the secondary that is picked, looking along the secondary and into the joint. | The default is set to Above. |
|
See also
Ayrshire cold rolled - Important informationAyrshire Non-Continuous Rail (106)
Ayrshire Non-Continuous Rail (106) - Parts tab
Ayrshire Non-Continuous Rail (106) - Bolts tab