Albion Eaves Brace (64) - Parameters tab
Environment
Not environment-specific
Use the Parameters tab in the Albion Eaves Brace Properties panel to control how the connecting members are defined within Tekla Structures.
Image
| Option | Description | Default | Other | ||||
|---|---|---|---|---|---|---|---|
| Face Strut to the (Left, Right) |
This controls the direction of the strut created. If this is set to Left then looking from the eaves beam selected to the purlin, the eaves brace will be orientated so that the strut faces to the left. The Right option similarly causes the eaves brace to face to the right. | The default is set to Left. |
|
||||
| Speed Fix Entry Position (Top, Bottom) |
This defines whether the speed-fix goes through the top holes (Bottom) or the bottom holes (Top). Use Top if angle struts are to be used. | The default is set to Top. | |||||
| Eaves Brace Type (Full Cleat, Half Cleat) |
This sets the type of cleat used on the purlin in the eaves beam to purlin connection. | The default is set to Full Cleat. | |||||
| General Bolt Grade | This sets the standard for all bolts added by the macro excluding those which may be placed to the web of the eaves beam. | The default setting is 4.6XOX. | |||||
| Eaves Beam Web Bolt Grade | This sets the standard for bolts placed to the web of the eaves beam. If this standard specifies countersunk bolts then a suitable packing plate will be added. | The default setting is 4.6XOX. | |||||
| Factory Fitting Type (Weld, Bolt) |
Eaves braces can be either factory bolted or factory welded. | The default is set to Weld. | |||||
| Group | This sets the class that all parts will be included in. | The default setting is 99. |
See also
Albion cold rolled - Important information
Albion Eaves Brace (64)
Albion Eaves Brace (64) - Parts tab