Albion Cold Rolled Cleat (110) - Parameters tab
Not version-specific
Tekla Structures
Environment
Not environment-specific
Use the Parameters tab in the Albion Cold Rolled Cleat Properties panel to control how the connecting members are defined within Tekla Structures.
Image
| Option | Description | Default | Other | ||||||
|---|---|---|---|---|---|---|---|---|---|
| Restraint Type (Standard, SW Cleat) |
To obtain the correct Albion cleat, set restraint type to SW Cleat. Selecting Standard will result in an RSA profile being used for the cleat. | The default is set to Standard. | |||||||
| Weld Cleat on (Near Side, Far Side) | This defines which side of the secondary member the cleat is welded to. | The default is set to Near Side. | |||||||
| Sheeting Line (Standard, Reversed) | Only available using the Restraint Type SW Cleat. This defines which side of the secondary member to use as the sheeting line. The Albion cleats are handed using a square hole in the top corner, this setting defines which side this hole goes to. | The default is set to Standard. | |||||||
| Free dist Primary to L Profile | This is used to specify the clearance between the cleats defined in the joint and the primary member. | If no value is entered here then the clearance will default to 0. |
Image
|
||||||
| Secondary member cut back | This determines the position to which the end of the secondary members are fitted, measured from the extremities of the primary member. | The default will give a minimum clearance of 5mm from the primary which will be rounded to give a whole value when measured from the centre-line of the primary. |
Image
|
||||||
| Angle Cleat Length | This parameter sets the length of the cleat. | This value will come from the data files. |
Image
|
||||||
| Place Cleats on (Left, Right, Both) | This specifies the positions where cleats are to be applied. The position is determined relative to the first secondary that is picked, looking along the secondary and into the joint. | The default is set to Left. |
|
See also
Albion cold rolled - Important information
Albion Cold Rolled Cleat (110)
Albion Cold Rolled Cleat (110) - Parts tab
Albion Cold Rolled Cleat (110) - Bolts tab