Command |
Description |
---|
Design members |
- If the member s are not in a design group -
- Performs a check or design (according to individual
autodesign settings) of the selected members.
- If the members are in design groups (and design using
groups is active)
- Performs a check of those members in the selection that
are in check mode.
- Performs a design of those members in the selection that
are in autodesign mode (for the group's set of design
forces), and:
- Updates all other members of the same group to use
the same design, (irrespective of whether they are
in the selection).
- Checks all other members of the same group
(irrespective of whether they are in the
selection).
|
Note: Design members does not
perform an analysis before the design - it always uses the existing analysis
results, (even if the analysis status is 'Out of Date').
Note: This command requires at least one
member in the branch to be in auto-design mode.