K Bracing

Tekla Structures
2021
Tekla Structures
2020
Tekla Structures
2019i
Tekla Structures
2019
Tekla Structures
2018i
Tekla Structures
2018
Tekla Structures
Environment
Not environment-specific

Contents

Purpose and description
System Requirements
Using the K Bracing
K Bracing settings
Additional information

Purpose and description

A component to easily and quickly add K bracing to a transmission tower.

System requirements

Tekla Structures.

Using The K Bracing

To use the component:
  1. From the component catalog select the K_Bracing component.
Image
Kthumbnail.jpg

  1. Select the parts in the model (2 No.)
Image
Cross_Partsl.jpg

  1. Select the input points
Image
Cross_Points.jpg

K Bracing settings

Parameters Tab

Image
KDialog.jpg


PropertyDescription
Image
KDims.jpg
Options to specify the bracing spacing dimensions.
 
All dimensions are along the leg.
Image
KBM.jpg
The Leg Gauge Line dimensions of the profiles are read automatically from the GaugeLines.dat file (in the model, firm or system folder).
These can be over written by the user if necessary.
Image
KCreate.jpg
Option to create the bracing groups.
If more than 5 groups are needed, then add another component in the model.
Image
KOffsets.jpg
Options to offset the brace ends along the legs.
 Offset Option to offset the bracing from the leg face.
Image
Cross_Construc.jpg
Option to show additional construction lines in the model on the Gauge line of the legs.

Diagonals Tab

Image
KDiagonals.jpg


PropertyDescription
Image
Cross_Profiles_tab_Gauge.jpg
The Bracing Gauge Line dimensions of the profiles are read automatically from the GaugeLines.dat file (in the model, firm or system folder).
These can be over written by the user if necessary.
Image
Cross_Profiles_tab_Profile.jpg
Option to specify the bracing profile.
The component is expecting equal L profiles and will not give the correct results with unequal profiles or other profile shapes.

Horizontal Tab

Image
KHorizontals.jpg


PropertyDescription
Image
DBHorizontals1.jpg
Option to specify the type and orientation of horizontal brace.
The component is expecting an equal L profile or a U profile, any other profile with give incorrect results.
Image
DBHorizontals2.jpg
Option to specify the bracing profile.
The component is expecting equal L profiles and will not give the correct results with unequal profiles or other profile shapes.
The Option to specify a U profile is inactive until the U option is selected (see above)

OffsetTab

Image
KOffset_Tab.jpg


Image
KOffset_Tab1.jpg
Option to offset the bracings allong the horizontal brace.

Additional information

  • The conponent only has the option for 5 groups of bracing, the first group is always created.
  • The Component direction must be set according to the directions shown in the dialog before applying
Oliko tästä apua?