XS_LONGHOLE_MARK_STRING_FOR_SIZE
Category in Advanced options dialog: Marking - bolts
Use this advanced option to define the contents of
the Size element in slotted hole marks. For example, enter
%BOLT_NUMBER%*D%HOLE.DIAMETER%(%HOLE.DIAMETER+LONGHOLE_MIN%x%HOLE.DIAMETER+LONGHOLE_MAX%).
This advanced option is only used when there is a slotted hole.
The advanced options
XS_SHOP_LONGHOLE_MARK_STRING_FOR_SIZE and XS_SITE_LONGHOLE_MARK_STRING_FOR_SIZE override this setting.
You can use any combination of text and the following options as the value for this advanced option. You can use the options in any order, and make calculations.
-
BOLT_NUMBER
-
DIAMETER
-
LENGTH
-
HOLE.DIAMETER
-
LONG_HOLE_X
-
LONG_HOLE_Y
-
LONGHOLE_MIN (the shorter of the slotted hole dimensions)
-
LONGHOLE_MAX (the longer of the slotted hole dimensions)
-
BOLT_STANDARD
-
BOLT_MATERIAL
-
BOLT_ASSEMBLY_TYPE
-
BOLT_COUNTERSUNK
-
BOLT_SHORT_NAME
-
BOLT_FULL_NAME
Enclose each option in % characters.
Note that if you are defining this advanced
option in an .ini file, use double percent signs
around the options. For example, %%BOLT_NUMBER%%*D%%HOLE.DIAMETER%%.
To use special characters, enter a backslash (\) followed by an ASCII number.
With length-type options, but not in
calculations, you can specify the number of decimals. For example, HOLE.DIAMETER.2 shows (tapped) hole diameters with two decimals.
This advanced option is model specific and the setting is saved in the options database.
See also
Define size in bolt marks using advanced options