Define the properties of a load

Tekla Structures
2021
Tekla Structures

Define the properties of a load

Before you create a load, it is a good idea to define or check the load properties.

  1. On the Analysis & design tab, click Load properties, and then click a relevant load type.

    For example, click Area load to define area load properties.

  2. In the load properties dialog box:
    1. Enter or modify the properties.
      • Select a load group.

      • Define the load magnitude, and the load form if needed.

      • Attach the load to a part or to a position.

        You cannot attach a load to a part after you have created the load.

        You can detach a load from a part after you have created the load.

      • Define the load-bearing parts.

      • If needed, adjust the loaded length or area.

      • If needed, modify the load distribution on the Load panel tab.

    2. Click OK to save the properties.

Tekla Structures uses these properties when you create new loads of this type.

Was this helpful?
Edellinen
Seuraava