Part mark position on assembly and single part drawings
Not version-specific
Tekla Structures
Environment
Not environment-specific
Question:
On which face of the part is the Part Mark placed in assembly and single part drawings?
Answer:
TS normally put the Part Mark on the 'Top' face of the part. However, if this is not possible (e.g 'Top View’ is being used), then TS puts the mark on the 'Back face'.
On which face of the part is the Part Mark placed in assembly and single part drawings?
Answer:
TS normally put the Part Mark on the 'Top' face of the part. However, if this is not possible (e.g 'Top View’ is being used), then TS puts the mark on the 'Back face'.
Image